Re: [squid-users] help on squid setup

Thanks guys,

I really apprecite your quick reply
i will try out your advices and check it out

and Mr Kaya u dont have to apologize at all . I should be indeed so
grateful to you that u spent your precious valuble time to read my mail n
to reply to it.

Thanks once again guys

regards

simon

> [...]
>>
>> I want to implement linux squid proxy server so that i have better
>> controls that is ( time based restrictions , ip based restrictions and
>> block certain web sites ) through squid ACLS
>>
>> I think i have to implement squid as a transparent proxy server with 2
>> lan cards on the squid server
>>
> [...]
>
> Hi Simon, you should be able to do all this from within the router if it
> is a fairly good one....
>
> The Cisco 88x and 89x series definitely do this very well and as for the
> 88x are ADSL capable! The 89x can be plugged into an ADSL modem or even
> Metro Ethernet solution or alternately backup line.
>
> http://www.cisco.com/en/US/products/sw/secursw/ps1018/products_tech_note09186a00800a5b9a.shtml
> {for ACLs}
>
> Anyhow what I'm trying to say is that it should take off the load of
> adding extra machines and also reduce overall cost too.
>
> However if you must use a Squid solution then here are some places to
> start:
>
> http://www.visolve.com/squid/
>
> http://www.squid-cache.org/Doc/config/
>
> and some config examples here:
>
> http://wiki.squid-cache.org/ConfigExamples/
>
> apologies for not being able to help further, however I only use squid
> as reverse proxy in my network environment.... :-)
>
> Hope this gets you started though!
>
> Regards,
>
> Kaya
>
>
>
>
>
> --
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
>

-- 
Network ADMIN
-------------
KUWAIT MUNICIPALITY:
-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.